Rock plate is a popular decoration material of equipment today, rock plate processing machinery plays a huge role in the processing industry, although the role is good, but if the processing does not pay more attention will appear a series of problems, so what are the common problems of rock plate processing machinery?

1. Cut

Rock plate cutting machine cut the edge of the zigzag marks or cut the sizes are different, leading to such a problem is usually the rock plate raw material is more brittle, or this rock plate cutting machine has no trim function.The cutting sizes are different, mainly when the cutting sheet produces moving, or is manually cut.The main solution is to use a brittle plate cutting machine with trim function of rock plate cutting machine, if the size difference can be reprocessed, if the difference is large, it should be a plate of other sizes.

2. The processed rock plate cannot meet the factory standard

The main reasons why the processed rock plate does not meet the factory standard are that the hardness or toughness ratio of the grinding wheel is greater than that provided by the instruction (the quality problem of the grinding wheel); motor wiring position reversed, large main vibration or transmission current; ceramic tile entrance greater than the specified limit; baffle displacement.Solution: replace the grinding wheel; check whether the motor, host and transmission current have resonance; the tile should be tightly pressed at the tile entrance; check the standard of the baffle plate, adjust the activity of the fixed baffle and the relative position of the baffle; improve the voltage in the workplace to meet the motor heavy load requirements.

Rock plate processing machinery is currently used more advanced equipment, mainly for the rock plate cutting, chamfer, grinding edge, trimming, polishing, etc.With the advantages of high processing efficiency and fast speed, it has been favored by various rock plate processing plants since its launch.